What Is The Basis For Setting Cooling Time Of Injection Molding Parts?

Mar 24, 2021

Leave a message

In injection production, the cooling time of plastic injection molding parts accounts for about 80% of the whole injection production cycle. Poor cooling often leads to warpage or surface defects, which affects the dimensional stability of products. Reasonable arrangement of injection, pressure holding and cooling time can improve product quality and productivity.

The cooling time of a part usually refers to the period from the time when the plastic melt fills the injection mold cavity to the time when the part can be taken out by opening the mold. The time standard for taking out the parts by opening the mold is usually based on the fact that the parts have been fully solidified, have certain strength and rigidity, and will not cause deformation and cracking when the mold is opened and ejected.

Even if the same kind of plastic is used for molding, the cooling time varies with the wall thickness, the temperature of molten plastic, the demoulding temperature of molded parts and the temperature of injection mold. The formula for calculating the cooling time with 100% accuracy in all cases has not yet been published, but only on the basis of appropriate assumptions. The calculation formula also varies with the definition of cooling time.

At present, the following three standards are usually used as reference for cooling time:

① The temperature of the center layer at the thickest part of the wall of the plastic injection molded part is the time required to cool below the thermal deformation temperature of the plastic;

② The average temperature in the section of plastic injection molded parts, the time required for cooling to the specified temperature of the product;

③ The center layer temperature of the thickest part of the wall of a crystalline plastic molding part, the time required to cool below its melting point, or the time required to reach the specified percentage of crystallization.

When solving the formula, the following assumptions are generally made:

① The plastic is injected into the injection mold, and the heat is transferred to the injection mold to be cooled;

② The plastic in the molding cavity is in close contact with the mold cavity, and does not separate due to cooling shrinkage. The heat transfer and flow between the melt and the mold wall have no resistance, and the temperature of the melt has become the same at the moment of contact between the melt and the mold wall. That is, when the plastic is filled into the mold cavity, the surface temperature of the part is equal to the mold wall temperature;

③ During the cooling process of plastic injection molded parts, the surface temperature of injection mold cavity always keeps uniform;

④ The results show that the surface of injection mold has a certain degree of heat conduction; (the filling process of molten material is regarded as isothermal process, and the material temperature is uniform);

⑤ The effect of plastic orientation and thermal stress on the deformation of the part can be ignored, and the size of the part has no effect on the solidification temperature.

 

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!