Tiling always feels particularly troublesome. In addition to the dirty cement mortar, tiling also tests the construction level of workers.
The so-called slow work out of detail, a tile after laying back and forth to confirm whether to pave, usually a few days to lay a kitchen and bathroom, if the room is also paved with tiles, it will take a longer time.
Domestic practices
Have laid ceramic tile, will notice to use white plastic small cross certainly.
These are the most popular tile spacer in China.
In the early years, when tiling, there was no tile spacers. The gap between the tiles could not be grasped too accurately. It all depends on what the worker master can catch.
The fastidious master uses nails, while the less fastidious master uses paper and wooden sticks.
Advantages of tile spacer
The ceramic tile itself will expand to a certain extent, and the edge of the ceramic tile itself is not 100% flat, so it is inevitable to leave the joint.
Even the seamless brick on the market at present is only with smaller gap, but it can't be absolutely seamless.
The tile spacer can effectively control the width of the gap between the tiles.
From the minimum gap of 1mm to the wide gap of 5mm, the tile spacer has corresponding specifications.
The use of the tile spacer is also very flexible. It can be vertically inserted in the gap, and then pulled out after the tiles are pasted, to specially handle the junction between the two tiles; or directly bury the whole clip into the junction of the four tiles, and align the four tiles at one angle at a time.
After paving, the sealant will not be visible and will not affect the use.
▲ cross card buried in the corner
▲ vertical cross card
Disadvantages of tile spacer
The tile spacer can only control the width of the gap to ensure the alignment of all ceramic tiles. The gap is the same width, but the surface of ceramic tiles cannot be treated smoothly.
Therefore, the key to tile leveling, as at the beginning, is entirely dependent on the craftsmanship of the bricklayer.
In addition, for areas such as toilets, it will affect the smooth drainage.
In order to ensure that the tiles are flat, the paving speed needs to be slowed down. The master needs to carefully check whether the tiles are flat.

If the tile spacer solves the gap problem of tiling from the perspective of two-dimensional plane, then the new artifact is the upgraded version
It not only solves the problem of uneven tiles, but also perfectly replaces the tile spacer.
Tile leveling system is a kind of auxiliary tool used to align and level the tiles when they are laid on the ground or wall. It almost eliminates the unevenness caused by tile warping in the
Curing process, reduces repair and saves installation time.

The reason is that such a good artifact has not been widely used in China.
Besides workers' slow access to new things, it also has something to do with cost.
However, it's always a little thing of icing on the cake. If you don't use it, it doesn't mean that the tiles are uneven or that you can do it yourself.
If you want to lay tiles with higher efficiency and smoother effect, you can try the convenience brought by innovation.
At present, the specifications of ceramic tiles in the market are getting larger and larger. Some large plates have reached 900x1800mm. In the process of tiling, it will be difficult to control the flatness of ceramic tiles with general methods. So it is a good way to apply the new tile leveling system.
