1, Extrusion: grades for extrusion production generally have a melt index of less than 1 and MWD of medium to wide. In the process of processing, the appropriate melt strength can be obtained with low MI. Wider MWD grades are more suitable for extrusion because they have higher production speed, lower die pressure and less melt fracture tendency.
2, Blow molding: more than 1 / 3 of HDPE sold in the United States is used for blow molding. These range from bottles of bleach, oil, detergents, milk and distilled water to large refrigerators, car fuel tanks and cans. The characteristic indexes of blow molding grades, such as melt strength, es-cr and toughness, are similar to those for sheet and thermoforming applications, so similar grades can be adopted.
3, Injection molding: HDPE has a wide range of applications, ranging from reusable thin-wall beverage cups to 5-gsl cans, consuming 1 / 5 of HDPE produced in China. The general melt index of injection grade is 5-10, with lower toughness and higher processability. Applications include thin-walled packaging for daily necessities and food; tough, durable food and paint cans; high resistance to environmental stress cracking applications, such as small engine fuel tanks and 90 gal garbage cans.
4, Roll molding: materials processed by this method are generally crushed into powder, which is melted and flowed in the thermal cycle. There are two types of PE used in roll molding: general purpose PE and crosslinkable PE. General purpose MDPE / HDPE usually has a density range of 0.935 to 0.945g/cc, with narrow MWD, which makes the product have high impact and minimum warpage, and its melt index range is generally 3-8. Higher Mi grades are generally not applicable because they do not have the impact and environmental stress cracking resistance that is desired for rolled products.
The high-performance rolling application system utilizes the unique properties of its chemical crosslinkable grade. These grades have good fluidity in the first stage of the molding cycle, and then crosslink to form excellent environmental stress cracking resistance and toughness. Wear resistance and weather resistance. Crosslinkable PE is the only one suitable for large containers, ranging from 500 gal tanks for transporting various chemicals to 20000 gal tanks for agricultural use.
5, Film: PE film is generally processed by blowing film or extrusion. Most PE is used for thin films, general purpose low density PE (LDPE) or linear low density PE (LLDPE) are available. HDPE film grade is generally used in places where superior tensile strength and excellent impermeability are required. For example, HDPE film is often used in commodity bags, grocery bags and food packaging.
