Construction steps of tile beautiful seam:
1.Prepare glue gun, wallpaper knife, scraper, bucket and textured paper;
2. Choose the color of the tile beautifying agent you like;
3. Poke a hole in the mouth of the ceramic tile sealant bottle, then screw on the discharge nozzle, and use a wallpaper knife to cut the discharge nozzle to a 45-degree angle (the tile gap is less than 2mm, and cut out the front end of the discharge nozzle with a wallpaper knife The slope angle is enough; if the tile seam is larger than 2mm, it can be slightly cut off; the width of the discharge nozzle should be smaller than the seam width to ensure that it does not overflow);
4. Clean up the site after entering the venue, use a wallpaper knife to clean the inside of the tile joints and the fillers on both sides, and no floating dust can be seen on the ground; then wet the sponge with water and quickly wipe the tile joints to confirm that there is no dust. , use the glue gun to evenly hit the beautifying agent in the tile seam;
5. Apply about one meter to block the discharge nozzle; then use a scraper to smooth the beautifying agent, and a small amount of beautifying agent overflows on both sides of the brick joints, wipe it off with a slightly damp sponge, and wipe it several times. The sponge should be watered frequently. Cleaning; wait for an area to be finished once and then start a second time from scratch to ensure the quality of construction;
6. It is necessary to make the edges flat, without air bubbles, and no overflow on the brick surface, and the ground should be as clean as new before leaving the site.
7. If you are constructing by yourself and you are afraid that the overflow on the brick surface will not be wiped clean, you can use textured paper to stick it on the edge of the brick seam, then use a glue gun to hit the material, scrape it with a scraper, wait for the material to dry, and repair it. When you are done, you can open the textured paper.
