How Many Parts Are There in The Molding Cycle Of Injection Mold Processing?

Jun 21, 2022

Leave a message

It actually includes the following parts: the molding cycle. The molding cycle directly affects labor productivity and equipment utilization. Therefore, in the production process, plastic mold manufacturers should try to shorten the relevant time in the molding cycle under the premise of ensuring quality. In the entire molding cycle, the injection time and cooling time are the most important, and they have a decisive influence on the quality of the product. The filling time in the injection time is proportional to the filling rate, and the filling time in the production is generally around 3-5 seconds.

18

The holding time in the injection time is the pressure time of the plastic in the cavity, which accounts for a large part of the entire injection time, generally around 20-120 seconds (the extra thick part can be as high as 5-10 seconds). minute). Before the melt at the gate freezes, the length of the holding time has an impact on the dimensional accuracy of the product, and if it is later, it will have no effect.

The cooling time mainly depends on the thickness of the product, the thermal and crystalline properties of the plastic injection molding, and the mold temperature. The end of the cooling time should be based on the principle of ensuring that the product does not change when it is demolded. Cooldowns are generally between 30 and 120 seconds.


Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!